The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Low Elco · 10-26-2016, 08:03 AM

its kind of a frame, the entire front rides on a piece of angle that's been relieved so that the pinch goes all the way in. it drops down about an inch. then you swing the back up and another angle bracket holds up the rear. Winds up with the tank roughly level with the top of the frame rails. Look in both threads in my sig, there's probably a good pic somewhere. Yeller is actually my dad's so it's up at his house. I've had the tank in and out 3-4 times since the truck's been built, easy peasy. I really just floated it where I wanted it on floorjack and lumber, then connected the dots with angle.

10-26-2016, 08:03 AM	#8
Low Elco Registered User Join Date: Apr 2003 Location: Indep, MO Posts: 5,893	Re: wrangler tank install ?????s its kind of a frame, the entire front rides on a piece of angle that's been relieved so that the pinch goes all the way in. it drops down about an inch. then you swing the back up and another angle bracket holds up the rear. Winds up with the tank roughly level with the top of the frame rails. Look in both threads in my sig, there's probably a good pic somewhere. Yeller is actually my dad's so it's up at his house. I've had the tank in and out 3-4 times since the truck's been built, easy peasy. I really just floated it where I wanted it on floorjack and lumber, then connected the dots with angle. __________________ Boppa's Old Yeller Truck Build, Old Yeller's New Heart! Project Buzz Bomb Flyin' Low!