The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**Baketown Scotty** · 10-31-2016, 08:30 PM

I am replacing the bearings on a Dana 60 front axle I got from a 1985 Chevy truck. The inner wheel bearing that I removed was a Timken 387-AS. The bearing that came in the kit from Yukon is Timken 387-A. According to the Timken website they both have a bore of 2.25". I can't get the new bearing on the spindle all the way on by hand. I probably could with some taps with a hammer. Is this normal?

10-31-2016, 08:30 PM	#1
Baketown Scotty Junior Member Join Date: Oct 2005 Location: Bakersfield, CA Posts: 324	Dana 60 inner wheel bearing I am replacing the bearings on a Dana 60 front axle I got from a 1985 Chevy truck. The inner wheel bearing that I removed was a Timken 387-AS. The bearing that came in the kit from Yukon is Timken 387-A. According to the Timken website they both have a bore of 2.25". I can't get the new bearing on the spindle all the way on by hand. I probably could with some taps with a hammer. Is this normal? __________________ 1964 Chevy Suburban 4x4 1966 GMC Suburban 4x4