View Single Post
Old 12-25-2016, 10:41 AM   #2
Anthony14
Registered User
 
Join Date: Apr 2014
Location: Brantford, Ontario
Posts: 87
Re: Minimal rear brakes...Proportioning / combination valve fun and education.

I'm actually in the middle of redoing my brake lines and converting to power brakes. My prop valve looks exactly like yours with that "pin" sticking out about 1/4". I've ordered the bleeder tool and its on its way. But what is the length suppose to be sticking out of the valve??

I took my sensor out of the top where the bleeder tool would install and I can see the brass components and the shuttle valve for lack of better terms and was able to move it back and forth with a flat head screwdriver, but as I did this that pin did not move and I can't seem to move it with pliers in or out...

Last edited by Anthony14; 12-25-2016 at 10:55 AM.
Anthony14 is offline   Reply With Quote