View Single Post
Old 04-03-2002, 01:34 AM   #1
Longhorn Man
its all about the +6 inches
 
Longhorn Man's Avatar
 
Join Date: Jan 2001
Location: Hilliard Ohio
Posts: 2,690
Thumbs up PONTIAC in Chevy pic

I tried takin a pic of the motor mounts, but it didn't come out, and since I am using the old 35mm, I won't get to retry till this weekend. However, here is the pic of the whole engine compartment.
OLDCHEV's friend, Jeff is a Pontiac fanatic, and said he looked at the numbers and off the top of his head believes it is a 350.
I know it has a tiny @ss 2 barrel carb, HEI, int. Reg. alt. on it, and lots of slime and oil on top of an almost ford lookin blue paint.
It looks like it was almost a bolt in afair, althoguh it does seem to sit a little higher than a Chevy small block.
After some research, i find the Pontiac 350 is actually a good motor for a truck. I do not remember the actual measurements, but I know it has the longest stroke of all G.M.'s 350 motors, which makes it a natural for high torque. I'm still putting it into the GMC and selling it though.


------------------
'69 G.M.C. 350/350. Trying to clean up the left over damage from the Dope-Smokin-Old-Man
I've been dubbed the Longhorn Freak/Fanatic/Expert, I just hope I can live up to it.
FINALLY got the HORNIAC...a '70 one ton Longhorn with a Pontiac 350/350 and lots of 'personality'. Check out The Longhorn Webite.
If you need a pic posted, E-mail me at longhornmail@yahoo.com
Andy, in Columbus Ohio




[This message has been edited by longhornmail (edited April 03, 2002).]
Longhorn Man is offline   Reply With Quote