The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

beautimus · 01-18-2017, 08:22 PM

pic 2 made a patch out of 3/16 steel. i heated it up and bent it, using a torch , bench vise and a big hammer. this made a made a piece of angle iron with a radius that was pretty close to the original. then i made pie cuts so that i could curve the upper lip.

01-18-2017, 08:22 PM	#2
beautimus Registered User Join Date: Mar 2002 Location: woodstock, alabama, usa Posts: 938	Re: front crossmember repair pic 2 made a patch out of 3/16 steel. i heated it up and bent it, using a torch , bench vise and a big hammer. this made a made a piece of angle iron with a radius that was pretty close to the original. then i made pie cuts so that i could curve the upper lip. Attached Images __________________ i survived cancer and kidney stones, but my kids are killing me.