Quote:
Originally Posted by custom10nut
I'm about to install my under dash courtesy lights.
My question is this
What is the best way to drill the holes to route the wiring for the door jamb switches?
From what I can tell I have to go through the door jamb, the inner cab panel and then the kick panel, up under the dash.
Is there a way to get around the panel that's in between?
I might take a trip out to my favorite salvage yard to look at one of the bare cabs.
|
If I understand your question, you're looking for the original route for the door jam switch? If so, there's a square shaped accretion in the door jam, maybe 3" below the top hinge. These are approximate measures, eye-only. If you need more info. I can do that.
There's a hole in the center of that square. It's threaded for the original door jamb switch (likely stripped if original Ha!).
There's a hole in the kick panel, which is 1" below and 1/2" to the rear of the dash panel's rear bottom corner.