The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**binford** · 01-20-2017, 01:17 PM

The stock manifold needs slight mod to fit. Using a torch and crescent wrench to make frame mod. here's a video of a swap.
https://www.powerblocktv.com/episode...p#.WIJEHk0zWUk

First question would be are you going to run A/C? if so then read this thread its a later year but same concept
http://67-72chevytrucks.com/vboard/s...d.php?t=413855

By moving the stock frame mounting bracket back an inch or so the A/C compressor will fit, otherwise you need to by the adapters to mount the compressor on top of the engine. The 67 should have pre drilled holes to move the mount back, but it's more like 2+ inches, so I might need to just drill some holes. I have not dropped the motor in yet to see just how it fits. Between the weather and other things needing attention.
Maybe next weekend.

01-20-2017, 01:17 PM	#19
binford Active Member Join Date: Aug 2004 Location: Sacramento Ca Posts: 141	Re: 67 Suburban 04 Suburban Engine The stock manifold needs slight mod to fit. Using a torch and crescent wrench to make frame mod. here's a video of a swap. https://www.powerblocktv.com/episode...p#.WIJEHk0zWUk First question would be are you going to run A/C? if so then read this thread its a later year but same concept http://67-72chevytrucks.com/vboard/s...d.php?t=413855 By moving the stock frame mounting bracket back an inch or so the A/C compressor will fit, otherwise you need to by the adapters to mount the compressor on top of the engine. The 67 should have pre drilled holes to move the mount back, but it's more like 2+ inches, so I might need to just drill some holes. I have not dropped the motor in yet to see just how it fits. Between the weather and other things needing attention. Maybe next weekend. Last edited by binford; 01-20-2017 at 01:36 PM.