[Scott2]

In an earlier episode I had started on the pass side kick panel and cowl repairs. There was a bunch of rust and the cowl was caved in from the door. I removed the cowl and cleaned up the rust, started to replace to bottom of the hinge pillar and front of the rocker. Also put in a smaller patch in the kick panel area but still had issues above that area.

This time I was able to finish that work and then cut a patch for the rest of the kick panel and got it welded in. Then I set the new cowl in place and decided to shave the vent. That turned out OK and the cowl is now fully welded in. Just need to come back with a little filler for the previously leaded seam and also will put a thin layer over the vent patch.