[MIKESAD50]

Well I put in a little time down at the shop. Mounted the passenger door. needs some adjustment, it does close and latch though.
Mounted the drivers mirror, I had already made up a lower radiator hose. I used vibrant performance products.
I started mounting the engine wiring harness and also drilled a hole in firewall recess to run throttle pedal, OBDII connector and ignition switch power for ECM. also shortened the drivers side O2 sensor wiring harness to clean up the harness install.
I still need to shorten the passenger side O2 sensor wiring. Need to run the B+ wire from alternator again.
Last thing I did was final trim and install an fitting on fuel supply to fuel rail, no picture of that.
I also brought the driver door home to install seal and other parts.
I bought another door seal. Also go the stainless lower door weather strip retainer, got a throttle and choke cable. I'm going to install in dash for the Original look and may try to incorporate a switch or something to make then functional for something, wipers, dash dimmer switch?