The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

keystoneGerm · 01-22-2017, 07:41 PM

These headers fit really well. They were removed from a c10, but wasn't sure what they were made for. I didn't want to run the hedman for our trucks because they hang too low for a slammed truck. I didn't want to give up the HP from a set of shorty's, so I am going to notch the cross member a bit on the P/S and the driver's side I can weld the exhaust at a slight angle to fit above the cross member. I had to make a bushing for the A/C bracket so all day today was project headers.

Next on the menu is the carb linkage and then onto the exhaust.

01-22-2017, 07:41 PM	#12
keystoneGerm Registered User Join Date: Jan 2017 Location: Fayetteville Posts: 46	Re: My contribution to a better society These headers fit really well. They were removed from a c10, but wasn't sure what they were made for. I didn't want to run the hedman for our trucks because they hang too low for a slammed truck. I didn't want to give up the HP from a set of shorty's, so I am going to notch the cross member a bit on the P/S and the driver's side I can weld the exhaust at a slight angle to fit above the cross member. I had to make a bushing for the A/C bracket so all day today was project headers. Next on the menu is the carb linkage and then onto the exhaust.