[midniteblues]

Wow just deleted a whole post lol...pita.

So the dimensions of the 1/4" thick center plate flattened out as plate steel would be 16 3/4"wide x 28"long.
Bent with a 9" leg at the bottom and the vertical fair lead leg is 8 tall".
Ok at the end I will recap all measurements.as my first post was wrong it's all made from 1/4" steel. I don't recall if that's 4 or 6 ga.

On too the mounting brackets
That are basically 3 1/2" x 2 1/2" angle @ 17 3/4" long

Hopefully most of us can read a tape that's not starting at
"The hook"
Now the end with the angle.
It starts 2" from the end and is 2" deep so it ends 4" from the
Atcual end of the channel.
Pretty sure that puts us rite about a 60 degree angle.

On too the 1 1/2" x 5" channel