Quote:
Originally Posted by LT7A
Thanks! That's good info. I'd like to get ahold of one of those intake manifolds for the weight savings. I have the not very common 14057055. It's cast iron though. Doesn't show up on the NastyZ casting list, but shows up in some threads.
|
I'm not sure how much weight it saves over cast iron, but I do like that it has mid rise runners. I feel it gives a bit more low end pull.
Quote:
Originally Posted by LT7A
Thanks again, back to trackin with your Scarlett improvements. I like how you are fitting the sound system to the truck, rather than cutting up the truck to fit the system. No disrespect to those that cut the truck to fit. I just like to preserve factory provisions where possible and then update the components where technology has advanced, or the factory had to compromise to be cost-competitive.
|
I'm not a purist by any means, but I have reservations about certain mods. I do not like a cut up dash and refuse to do so if possible.
Wait to you see how I am mounting the KMC20 controller. I was able to come up with a method that doesn't require cutting the dash or the stock bezel.