Quote:
Originally Posted by mongocanfly
Don't mess with the gauge..more than likely its going to be the sending unit or wiring at the sending unit..easiest way is pick bed up..take the hold down bolts out on the tank side and loosen the ones on opposite side (really loose)..you can then tilt bed by lifting it and sticking a 2x4 in there to hold it up at an angle..you should be able to work on it from there...much easier than trying to pull a tank full of gas.
..remember..that's a gas bomb your working on...
|
Good advice. I wasn't particularly looking forward to dropping the tank. This sounds much easier. The ground for the sending unit should connect to the frame somewhere pretty close to where the sending unit is, correct? So, I should have access to most of the wiring by doing this?