Quote:
Originally Posted by homemade87
I see you put a cam in . If you did not take the time to check preload on the lifters with the correct push rods length its very possible you will get some noise . Not sure how bad yours is but most ls motor will have a little lifter noise with a cam swap . Mostly with the bigger lift . Dont know how small your lift is and may not be that significant on your engine .
Also most aftermarket cams have a different base circle and will require different push rods . I would check with your cam supplier and see what is required .
This may be one other clue ( when the engine warms up ) . Could be an exhaust manifold leak . Some will not leak until warmed up . Sounds like a lifter tick .
Just a couple thinks to think about .
|
I had a speed shop install cam and new pushrods along with rebuild heads. I'm hoping it's a header leak. Going to pull them off tonight and see.