The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

62 Barnfind · 04-23-2017, 12:15 PM

I did a rear tank conversion on my 62 during the second rebuild. I thought it was working right until I ran out of gas one night. I was told that the gauge was a 30 OHM not a 90 so I ordered and installed the 30 OHM gauge. No luck with the proper reading. It sits right below the half mark and moves a little when the power is on. It has power to the gauage, the sender is grounded and I have a new wire running up to the fuse box. What am I missing?

04-23-2017, 12:15 PM	#1
62 Barnfind Registered User Join Date: Jan 2012 Location: Salado, Tx Posts: 1,385	Fuel Gauge not working I did a rear tank conversion on my 62 during the second rebuild. I thought it was working right until I ran out of gas one night. I was told that the gauge was a 30 OHM not a 90 so I ordered and installed the 30 OHM gauge. No luck with the proper reading. It sits right below the half mark and moves a little when the power is on. It has power to the gauage, the sender is grounded and I have a new wire running up to the fuse box. What am I missing? __________________ John Z 1962 Chevy C10 Stepside 62 Barnfind My build tread: http://67-72chevytrucks.com/vboard/s...d.php?t=507513 Last edited by 62 Barnfind; 04-23-2017 at 07:32 PM.