View Single Post
Old 05-02-2017, 02:43 AM   #1
Rockyrob
Registered User
 
Join Date: Dec 2016
Location: Brisbane Australia
Posts: 18
MAnual oil guage needle position

My manual gauge needle reads half way when not running ( or even connected) and then goes off the dial when running to the point of not being able to see the needle, . Pushing it back to the low stop it just springs back to vertical (half way) Is there a way to calibrate to get it back to read nil at stop ,that way it should read half three quarters running. Or can I take the needle off and reposition it . Gauge is just hooked up to move car while I wait for dash parts it reads the same even if out of car

Thanks in advance
rob
Attached Images
 
Rockyrob is offline   Reply With Quote