The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

chevylookin · 05-08-2017, 10:12 AM

For me, I hate cutting holes in anything. I even felt guilty making a new hole for in the trans hump cover doing a tranny swap. Are the lower rear quarters on your rig already rusting out? Is it something you think you might have to do sooner or later? If so, dont hack up your inside panels. On the other hand, the whacky PO already butchered a hole or two in it so that needs to be mended and fixed or it needs about 2 more on each side to make it match. Are you going back to stock? Or are you going to put some gucci interior in it someday and you could easily conceal the access covers?

05-08-2017, 10:12 AM	#2
chevylookin Registered User Join Date: Mar 2011 Location: garden grove Posts: 175	Re: Access panel or not? Need some opinions! For me, I hate cutting holes in anything. I even felt guilty making a new hole for in the trans hump cover doing a tranny swap. Are the lower rear quarters on your rig already rusting out? Is it something you think you might have to do sooner or later? If so, dont hack up your inside panels. On the other hand, the whacky PO already butchered a hole or two in it so that needs to be mended and fixed or it needs about 2 more on each side to make it match. Are you going back to stock? Or are you going to put some gucci interior in it someday and you could easily conceal the access covers?