The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Hypertrophy · 06-15-2017, 04:29 PM

It's a 400 Turbo. 3 speed Automatic. I installed a 454 with a 400 Turbo attached to it. I removed a 383 Stroker with a 400 Turbo attached to it. The tail shaft of the new engine/trans slide right in. Then when I went underneath to tighten everything I saw the spindles showing. Of course I don't remember if they were showing when I removed old engine/trans. No previous drivetrain issues...but I wanted to make sure I didn't cause this installing new combo, which seems nearly impossible because it's bolted/fixed position at both ends.

06-15-2017, 04:29 PM	#4
Hypertrophy Registered User Join Date: Apr 2017 Location: Louisville, KY Posts: 10	Re: Is this normal (Pic) It's a 400 Turbo. 3 speed Automatic. I installed a 454 with a 400 Turbo attached to it. I removed a 383 Stroker with a 400 Turbo attached to it. The tail shaft of the new engine/trans slide right in. Then when I went underneath to tighten everything I saw the spindles showing. Of course I don't remember if they were showing when I removed old engine/trans. No previous drivetrain issues...but I wanted to make sure I didn't cause this installing new combo, which seems nearly impossible because it's bolted/fixed position at both ends.