The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Miner69er · 07-13-2017, 06:07 PM

Thanks Randy. I just assumed that the clips I purchased from Brothers were the correct ones. They also have a youtube video on how to align the moulding, drilling the holes for the same clips I bought, but doesn't show them actually installing said nuts.....

The 72 that I just purchased was restored a few years ago, and they did a top notch job, except when it comes to the trim. One side has sheet metal screws driven straight through the face and the drivers side put on with several attempts at glue, gasket maker, and double sided tape. All are not acceptable, at least to me.

07-13-2017, 06:07 PM	#3
Miner69er Registered User Join Date: Mar 2017 Location: South Jordan, UT Posts: 4	Re: Upper Bedside Moulding Question Thanks Randy. I just assumed that the clips I purchased from Brothers were the correct ones. They also have a youtube video on how to align the moulding, drilling the holes for the same clips I bought, but doesn't show them actually installing said nuts..... The 72 that I just purchased was restored a few years ago, and they did a top notch job, except when it comes to the trim. One side has sheet metal screws driven straight through the face and the drivers side put on with several attempts at glue, gasket maker, and double sided tape. All are not acceptable, at least to me.