View Single Post
Old 07-21-2017, 10:38 PM   #6
53chevyforever
Registered User
 
53chevyforever's Avatar
 
Join Date: Jul 2010
Location: texas
Posts: 180
Re: AC Vents dash installation 66 C10

Quote:
Originally Posted by AcampoDave View Post
I'd like to know more about the vents. Do they open and close or just rotate? Do they turn 360 degrees? Is the trim bezel ample enough to provide a bit of coverage in case the hole gets a bit out of round? And lastly, do you have a part.# for those. I want to do the same deal and have been looking at them on the net, but it'd be nice to have a first hand report.
First...vents just rotate...and will turn 360 degrees the trim bezel is very close...that is why I used the
sand paper rolls in the die grinder after drilling the hole so not to remove too much material to make it fit snugly.
I don't have a part number but there are many different vents you can
get from vintage air or old air products..if I were buying new ones I would
get the triple vein...mine are the dual. I think this is the vintage part number but don't hold me to it (Louver 490535) If you do this be sure to use a dial caliper..not a tape measure...good luck!
53chevyforever is offline   Reply With Quote