Quote:
Originally Posted by 72MARIO
I read thru your post but couldn't find the answer. Where is your tempature sending unit ? And are you using dakota digital sender or the GM in drivers front of block and the BIM-2 interface to display what the pcm is seeing ?
|
Yes, I'm using Dakota Digital with the BIM-2 module that plugs into the diagnostic port (ODBII). No sensors, gauges should be getting PCM data.
- I did pickup a code scanner, data reader
- New coolant
- New thermostat
- Manual temp gauge
Will attempt to pull data on cool start this morning to see if numbers are different than Dakota Digital.