Next up wiring (4th of July weekend
) !
First I went and took some reference photos off of the 67 to see where the wiring harness was supposed to be routed. (Damn that thing is dirty!)
I used some cable clamps to hold the harness to the driver fender well and I had to drill a couple of holes in my “new” fan shroud but it all went in and fit.
I had to terminate the alternator hot wire and ground wire and I also made my final solder joint in the temperature sensor wire (initially wasn’t sure which side I would end up using). After that the temp gauge read correctly. Unfortunately I did not get any photos of that bit.
-Richard