View Single Post
Old 08-20-2017, 01:12 PM   #17
gmachinz
Account Suspended
 
Join Date: Jun 2011
Location: Des Moines, IA.
Posts: 4,143
Re: Id'ing original sheet metal?

Here are a couple pics of an aftermarket LH front fender on an 81-up parts truck I have-notice the lack of alignment pinches in the general area where they are in the above GM fender pics. These pics are of the front and back of the front LH fender lip-the lack of the proper alignment pinches near the wheel trim holes indicate this truck has aftermarket front fenders. This is what I look for when shopping for used or junkyard fenders.
Attached Images
  
gmachinz is offline   Reply With Quote