Quote:
Originally Posted by Alberta65
Excuse my lack of electrical knowledge but how do I test for continuity to the ground? I check the bulb with a multimeter it's fine also if I touch the end of the wire from the light and the bulb it checks out so that part appears to be fine....
Side note it is a halogen bulb and the tail lights are leds would that be creating an issue?
Posted via Mobile Device
|
Set your meter on the ohms scale and touch one lead to the socket and the other lead to a clean spot on the frame. If the meter needle goes to "0" or near "0" then you have a good connection between the two. If the meter needle doesn't move or stays high than you've found your problem.