View Single Post
Old 11-30-2017, 03:55 PM   #3
Sleipnir
Registered User
 
Join Date: Oct 2017
Location: Seguin, TX
Posts: 89
Re: WTB - Single Barrel Rochester Carbs

Quote:
Originally Posted by Grumpy old man View Post
Just a heads up ,You can't just bolt 3 stock carbs onto the manifold and expect it to work , You have to remove the choke plate and idle circuit on the front and rear carbs and add a progressive linkage , Only the center carb feeds the engine until about 20% throttle then the outer carbs start to kick in .check out Speedway motors and a uni-syn

For years customers have been either putting up with poor idling multiple carburetor set-ups or spending hundreds of dollars converting the secondary carburetors so they did not have to idle circuits


https://www.ebay.com/itm/Uni-Syn-Car...-/151717668361

https://www.speedwaymotors.com/Garag...sh,250690.html
Chrome is a little much for me but I did find the triple plain kit which is nice but expensive. Not to mention buying the adapters to bolt them to the Offy intake and then buying the linkage and the gauges to tune them. I mean its not a bad idea but it'll be over $1000 for that kind of setup.
Sleipnir is offline   Reply With Quote