|
Re: LT1 GenV swap
Hadn't made much progress, the fuel pressure regulator housing I bought didn't fit the regulators I had - so it got sent off to the machine shop, been there for a week or 2. Got the temporary fuel pump setup ready. I say temporary since the pump data sheet says it can draw a few more amps than the connector can support... so I will measure it once it's up and running. I have a backup plan just incase.
Made a fuel pump mount to hold the pump on the 5/16 tube, used the flex intank hose just to be e85 safe. If I wasn't going to run e85, stock setup would work. Couldn't find a single e85 submersible rated hose though.
3/8 feed, 3/8 return and 5/16 transfer from the other tank.
Clint
__________________
1987 Silverado - L83 5.3 w/ 6L80e ,A/C,P/W,P/L,TILT, HID projectors, Wilwood C-10 Pro Spindles w/ 2018 silverado front brakes & C-5 Corvette Rear Disc Brakes
1999 BMW 528i - 5.7 LS1 w/ 4l60e, Ford 8.8 IRS w31 spline posi & FX-r projector retrofit
New project: 2006 BMW x5 6cyl AWD to L83 6l80e 4wd to 2WD / RWD
A poor man buy's it twice
finally got my domain name back, 87chevy.com.... site rework in progress
|