The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Getting 27x11-15 drag slicks to tuck into bed sides?

Robznob11 · 01-02-2018, 02:49 PM

I run a 15x12 with 6.5 bs, but it was tight. I trimmed my fender lips and welded in flat plate. 15x 12 with 7.5 bs would be better but im on bags too. I think with your drop that the 15x10 w/ 5" bs will be fine with tubs only. First two are with frame setting on axle. Last is ride hight. Get the long track bar and center it for ride hight. The longer and more level the track bar at ride hight will help with the side to side shift and pretty much eliminate any rubbing

01-02-2018, 02:49 PM	#2
Robznob11 Registered User Join Date: Feb 2004 Location: brownfield texas (west texas) Posts: 1,937	Re: Getting 27x11-15 drag slicks to tuck into bed sides? I run a 15x12 with 6.5 bs, but it was tight. I trimmed my fender lips and welded in flat plate. 15x 12 with 7.5 bs would be better but im on bags too. I think with your drop that the 15x10 w/ 5" bs will be fine with tubs only. First two are with frame setting on axle. Last is ride hight. Get the long track bar and center it for ride hight. The longer and more level the track bar at ride hight will help with the side to side shift and pretty much eliminate any rubbing Attached Images __________________ The Ghost 67 short wide full custom. 550 hp LSX, 4l80E, narrowed 9". Body dropped w/air ride! ........................ ___ .........________//__{\_____ ,,,,,,,/__(⊙)___//___/__(O)_/ @disciple2.rc 💪instagram💪 LED TAILS Last edited by Robznob11; 01-02-2018 at 10:24 PM.