Re: '97 Chevy Tahoe (2dr/2wd) mild custom
So I removed the old light & harness wires, just leaving the plastic base. I used my Dremel & also hand-sanded the plastic smooth. I also had to fill the old holes & did so with JB Weld Plastic, sanding smooth again after it set. Then I drilled a hole into the plastic base to fit the new LED light.
No new pics yet, but I'm in the process of connecting the new light wiring to the old. I put a coat of white spray paint on the plastic base to clean it up, & I cleaned/polished the clear plastic housing/lens.
Tag light removed (bottom) by likaroc13, on Flickr
tag light removed (top) by likaroc13, on Flickr
Hole drilled for new light by likaroc13, on Flickr
New light test fit by likaroc13, on Flickr
New light test fit w/ housing by likaroc13, on Flickr
New light test fit w/ housing by likaroc13, on Flickr
|