The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Measuring for a new driveshaft

bs46488 · 01-05-2018, 05:57 PM

My shop said pull the yoke out 3/4"

If I remember correctly it was around 58 3/4", but I have a TH400 trans in mine.

01-05-2018, 05:57 PM	#4
bs46488 Registered User Join Date: May 2014 Location: San Diego, CA Posts: 547	Re: Measuring for a new driveshaft - does this make sense? My shop said pull the yoke out 3/4" If I remember correctly it was around 58 3/4", but I have a TH400 trans in mine. __________________ Project Engine Stand 1972 SWB conversion: http://67-72chevytrucks.com/vboard/s...d.php?t=673914 1970 Nova: http://67-72chevytrucks.com/vboard/s...d.php?t=708161