The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - CA Anybody parting out a 64-66 junk cab? Dash part needed.

**aotte1** · 01-06-2018, 12:50 AM

Could use 3M panel adhesive to install it. Cut it flush on dash surface, use a small metal piece under seam, installed with the 3M panel adhesive. You can leave a small amount of adhesive on dash surface at seam. After dry, sand smooth.

The dash patch and underneath metal piece can be held in place to dry with small screws. Test fit to see how many screws are needed to align it. Once dry remove the screws and fill holes with the 3M adhesive.

Les

01-06-2018, 12:50 AM	#9
aotte1 Registered User Join Date: Oct 2013 Location: lousiville Ky Posts: 2,645	Re: Anybody parting out a 64-66 junk cab? Dash part needed. Could use 3M panel adhesive to install it. Cut it flush on dash surface, use a small metal piece under seam, installed with the 3M panel adhesive. You can leave a small amount of adhesive on dash surface at seam. After dry, sand smooth. The dash patch and underneath metal piece can be held in place to dry with small screws. Test fit to see how many screws are needed to align it. Once dry remove the screws and fill holes with the 3M adhesive. Les