View Single Post
Old 02-07-2018, 10:49 PM   #5
statenine
Registered User
 
statenine's Avatar
 
Join Date: Feb 2017
Location: Torrance, CA
Posts: 56
Re: CPP engine mount perches question

Quote:
Originally Posted by Clyde65 View Post
Should be 3 holes on each side on top rail.

Hole on crossmember is to the rear only. If your putting in front two holes of frame rail, you will need to drill.
Thanks Clyde, however mine only has 2 holes on the drivers side. Also, when I put the perch in the front 2 holes of the frame rail, the bottom mount aligns perfectly with this hole:
Attached Images
 
statenine is offline   Reply With Quote