View Single Post
Old 02-08-2018, 01:56 PM   #8
statenine
Registered User
 
statenine's Avatar
 
Join Date: Feb 2017
Location: Torrance, CA
Posts: 56
Re: CPP engine mount perches question

Thanks all. Yeah, so if I use the front 2 holes, I will only need to drill one hole on the driver side frame rail and would then be done.

If I use the rear 2 holes, I will need to drill 2 new holes in the crossmember.

I am fine going either way, just don't know if there is a "correct" way...
statenine is offline   Reply With Quote