The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Can't secure ebrake cable at pedal assembly

Rufas · 02-20-2018, 01:13 AM

I'm missing something here. I replace my ebrake cable and attached it to the ebrake assembly in the cab. But there is nothing to secure the cable to. The whole cable just moves went I apply the ebrake.

I have the foot operated ebrake lever in a 1970 GMC. Just what am I missing?

Here is a photo of where the cable attaches to the ebrake assemble. I don't see anywhere to lock the cable to keep it from moving.

LMC shows some type of clip (red arrow - number 13), but where does it attach?

02-20-2018, 01:13 AM	#1
Rufas Registered User Join Date: May 2016 Location: Fort Mohave, AZ Posts: 371	Can't secure ebrake cable at pedal assembly I'm missing something here. I replace my ebrake cable and attached it to the ebrake assembly in the cab. But there is nothing to secure the cable to. The whole cable just moves went I apply the ebrake. I have the foot operated ebrake lever in a 1970 GMC. Just what am I missing? Here is a photo of where the cable attaches to the ebrake assemble. I don't see anywhere to lock the cable to keep it from moving. LMC shows some type of clip (red arrow - number 13), but where does it attach? __________________ 1970 GMC 2500 700R Trans, RideTech 4 link rear suspension, air bagged on all four corners, factory upper/lower A-Arms, 2 inch drop spindles. 350 SBC 300hp Weiand Supercharger FiTech 30004 EFI