Quote:
Originally Posted by kwmech
I would just replace the 3/8'' line so it goes through the floor correctly. I would then flare the end of the tube with a fitting on it then connect a 5/16 barb/3/8'' tubing nut fitting on the end. Cost of those parts would be about 5-10 dollars instead of a complete sending unit assy. but that's just me. I probably have all the parts in the garage
|
So do you think that's actually a 5/16" sending unit?
I guess the main issue perhaps with going your rout is, I have no fuel line bending tools. I'd have to buy a pre-bent line.