Quote:
Originally Posted by FAKKY
Looks awesome
A month or two behind you .....
Hows the transmission tunnel fitment - 4l60e right ? --- you had to modify it looks like
Any tips for engine install/alignment and wiring or issues hit.
Good stuff.
|
Awesome to hear your a month or two behind,
The transmission tunnel probable didn't need as much trimming as i did because i had the tranny set a 0 angle when i did it, not a 3 degree so you might have to take out some.. I also had to trim one of the ear on the passenger side for the long tube headers to get by the 4l80E, dont think you'd have a issue with a 4l60e.
I actually rewire the original harness, did it twice once for a 5.3 and now for the 6L, think the sites lt1swap (lots of information), I totally pulled a part the wire harness, Id leave it in form it was again and leave the computer in the engine bay.. I"m going to rewire and lengthen another harness next winter to move the computer behind a seat or you could just buy a harness.. IN the end that would have been way way easier....