The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Rufas · 03-26-2018, 09:33 AM

I'm using the sequential rear turn signals from Brother's. I did have to install a solid state flasher and keep the front turn signal 1157 bulb. I kept the front bulb because I didn't want to use the load resistors. No problems with interfering with the trans. But then again I'm using a 700R.

03-26-2018, 09:33 AM	#2
Rufas Registered User Join Date: May 2016 Location: Fort Mohave, AZ Posts: 371	Re: LED Tail Light Question I'm using the sequential rear turn signals from Brother's. I did have to install a solid state flasher and keep the front turn signal 1157 bulb. I kept the front bulb because I didn't want to use the load resistors. No problems with interfering with the trans. But then again I'm using a 700R. __________________ 1970 GMC 2500 700R Trans, RideTech 4 link rear suspension, air bagged on all four corners, factory upper/lower A-Arms, 2 inch drop spindles. 350 SBC 300hp Weiand Supercharger FiTech 30004 EFI