The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Cbo68 · 03-26-2018, 10:54 PM

Go to harbor freight and get you their hammer and dolly set. I wouldn’t spend a lot of money on a set unless you’re going to make a career out of it. It’s not difficult work just do your best to get them back to contour. You’ll then have to clean up any remaining damage from beating on them with some body filler.

Recommend getting on YouTube and watching the hammer and dolly process if you’ve never done it.

Every aftermarket piece I’ve purchased has had damage on it. Just expect to hammer on it them everytime.

03-26-2018, 10:54 PM	#2
Cbo68 Registered User Join Date: Mar 2018 Location: Kent Washington Posts: 43	Re: Aftermarket door damage Go to harbor freight and get you their hammer and dolly set. I wouldn’t spend a lot of money on a set unless you’re going to make a career out of it. It’s not difficult work just do your best to get them back to contour. You’ll then have to clean up any remaining damage from beating on them with some body filler. Recommend getting on YouTube and watching the hammer and dolly process if you’ve never done it. Every aftermarket piece I’ve purchased has had damage on it. Just expect to hammer on it them everytime.