View Single Post
Old 05-12-2018, 05:07 PM   #6
cruizin01
Registered User
 
Join Date: Mar 2016
Location: Cbus, Ohio
Posts: 290
Re: A/C line, condener, dryer components and fitment issues

Update.

I went ahead and purchased the lines above.

They are just what I needed. My rad support has the hole for the grommet and it positions the lines correctly as well. I need to mount my condenser before installing them.

On that note I found some hardware from classicparts.com that appear to be what Im after to mount the condenser.



They should fit through the large hole in the rad support and then a bolt is used to hold the condenser in place. Maybe I could find these locally but Im just gonna order them along with the bolts.

I was also able to get the dryer to fit by bending the evap line a bit. It was a little softer than I was expecting so that gets me the room I need.




I need to come up with a bracket yet. Ill may try and make something that holds the line in place versus using the big round dryer bracket. We'll see.

I still need to order a new switch. I believe the one I need for the dryer is a high pressure switch, correct?

But that still leaves me with an opening on the liquid line to the evaporator. It doesn't appear to be used on later trucks thus I have no connector on my harness. I think it can be wired in series but Im not sure what switch I need. I found a couple that claim to be low pressure. All the pictures I can find make it seem like the bottom picture is used for the dryer but should that be on the high side? maybe it doesn't matter?

__________________
'78 C10 Build
cruizin01 is offline   Reply With Quote