The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Pulling the 250 i6 and 4-speed with granny low gear from 1964 c10

Old Truck Man · 05-13-2018, 02:46 PM

If it was me I would leave the granny 4 speed and bellhousing in the truck. Its really simple to take apart and reinstall that way. You can remove the floor mat and unbolt the center floor pan to gain access to the trans and bellhousing to clean and paint then. You are going to have to remove the center floor pan any how if you try and remove the engine and trans as a unit.

05-13-2018, 02:46 PM	#3
Old Truck Man Registered User Join Date: Feb 2014 Location: Pocahontas Arkansas Posts: 684	Re: Pulling the 250 i6 and 4-speed with granny low gear from 1964 c10 If it was me I would leave the granny 4 speed and bellhousing in the truck. Its really simple to take apart and reinstall that way. You can remove the floor mat and unbolt the center floor pan to gain access to the trans and bellhousing to clean and paint then. You are going to have to remove the center floor pan any how if you try and remove the engine and trans as a unit.