The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Johns327 · 06-04-2018, 10:24 PM

Thanks all.
Found my issue with the draggy brakes. There was this dust cover on the master that was holding the piston from releasing pressure.
As far as which of the two ports I went ahead and swapped them. Now the port closest to the flange is connected to the rear brakes.
Mostly YEAH the brakes are acting correctly, now on to steering!

06-04-2018, 10:24 PM	#6
Johns327 Registered User Join Date: Jun 2017 Location: Bonsall, CA Posts: 104	Re: Master cylinder connection Thanks all. Found my issue with the draggy brakes. There was this dust cover on the master that was holding the piston from releasing pressure. As far as which of the two ports I went ahead and swapped them. Now the port closest to the flange is connected to the rear brakes. Mostly YEAH the brakes are acting correctly, now on to steering!