The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

MARTINSR · 06-10-2018, 10:55 PM

I'm sorry guys, what information I am after is how it looks, does it hang over much? I had forgotten about the side skirts. Outside of the side skirts does any of the seat hang over on the sides or front or inside?

I am looking to section this riser that is welded onto the floor. The cab is sectioned a few inches and the top is chopped three and a half so I need to lower the seat down and I need to know how much I can section this riser.

It looks like in those drawings that the seat track mounts to those two holes in my last photo. If that's the case I am out of luck.

Brian

06-10-2018, 10:55 PM	#4
MARTINSR Registered User Join Date: Dec 2000 Location: Boise, Idaho Posts: 6,003	Re: How does the seat bolt into an AD? I'm sorry guys, what information I am after is how it looks, does it hang over much? I had forgotten about the side skirts. Outside of the side skirts does any of the seat hang over on the sides or front or inside? I am looking to section this riser that is welded onto the floor. The cab is sectioned a few inches and the top is chopped three and a half so I need to lower the seat down and I need to know how much I can section this riser. It looks like in those drawings that the seat track mounts to those two holes in my last photo. If that's the case I am out of luck. Brian __________________ 1948 Chevy pickup Chopped, Sectioned, 1953 Corvette 235 powered. Once was even 401 Buick mid engined with the carburetor right between the seats! Bought with paper route money in 1973 when I was 15. "Fan of most anything that moves human beings"