Quote:
Originally Posted by randy500
I was going to mention the spring and horn contact but you can see them in them installed in the first picture. Looks like he is covered on that.
|
Again, my above posted comment was only addressing the last part of your below
(in bold) instructions/reply to the original thread starter Lancialonnie. A whole lot of folks look back upon these board threads for info and guidance, so if/when I see incorrect info or instructions added I will always try and note/add the correct info. Mel
Quote:
Originally Posted by randy500
Your factory tilt column has a non tilt turn signal switch installed, order the cancel cam for non tilt.
|