[chrismoore701]

Update: i learned some valuable lessons today. Took a couple pics and looked like it was clogged. Found a flexible drill bit that i was able to get the bit into the vent hole. Started to drill. And drill. And drill. My buddy came over and stopped me. Started researching a little more and realize it was not plugged. I was drilling through the wall that is just inside the hole. Dropped the pan. Hit the dipstick tube with a small shot of air. Vent clear. That’s all i needed to do. Checked the pan for square. Front has a 0.034” gap between the bolts. I assume this is the problem. Going to email the company tomorrow. Thoughts on this gap? It’s right where it is leaking. Should i get that lube locker gasket?