The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**1rippen6** · 08-20-2018, 11:09 PM

No didn't try to loosen the bolts. I think the threads where the handle bolts are good but will double check. That's the only one I've seen but it does have a lot of paint on it. I can get you some pictures of the corners by the glass. I may have plates if they are rusted I've replaced them before they are only pop riveted in I'll check tomorrow. I'm getting ready to part that blazer so I can take the hatch off and get a lot better look at it in a couple of days.

08-20-2018, 11:09 PM	#8
1rippen6 Senior Member Join Date: May 2011 Location: Greencastle PA Posts: 6,717	Re: WTB Blazer hatch No didn't try to loosen the bolts. I think the threads where the handle bolts are good but will double check. That's the only one I've seen but it does have a lot of paint on it. I can get you some pictures of the corners by the glass. I may have plates if they are rusted I've replaced them before they are only pop riveted in I'll check tomorrow. I'm getting ready to part that blazer so I can take the hatch off and get a lot better look at it in a couple of days.