The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - A MUST have "cutting oil" to have in your garage.

MARTINSR · 08-23-2018, 12:50 AM

I may have posted this before, but it just blows me away every time I use it and have to scream from the roof tops GET SOME OF THIS!

This stuff is for tapping, but it works for drilling and even sawing metal with a hack saw! I cut a bunch of metal tonight, eighth inch angle iron and channel iron. Putting a drip of this oil on the cut then proceeding cutting with the hand hack saw and it goes from cutting metal to cutting a friggin piece of balsa wood! OMG what a difference! Drilling, the drill goes through the metal like it's a pencil through a piece of paper!

Honestly buy some of this stuff!

Brian

08-23-2018, 12:50 AM	#1
MARTINSR Registered User Join Date: Dec 2000 Location: Boise, Idaho Posts: 6,043	A MUST have "cutting oil" to have in your garage. I may have posted this before, but it just blows me away every time I use it and have to scream from the roof tops GET SOME OF THIS! This stuff is for tapping, but it works for drilling and even sawing metal with a hack saw! I cut a bunch of metal tonight, eighth inch angle iron and channel iron. Putting a drip of this oil on the cut then proceeding cutting with the hand hack saw and it goes from cutting metal to cutting a friggin piece of balsa wood! OMG what a difference! Drilling, the drill goes through the metal like it's a pencil through a piece of paper! Honestly buy some of this stuff! Brian Attached Images __________________ 1948 Chevy pickup Chopped, Sectioned, 1953 Corvette 235 powered. Once was even 401 Buick mid engined with the carburetor right between the seats! Bought with paper route money in 1973 when I was 15. "Fan of most anything that moves human beings"