|
Re: Standalone Harness - what to wire in
Tryin to decipher your question here.
From the stand alone harness to inside the truck, what wires do you need to come out?
If your standalone harness relay/fuse block is in the engine compartment you will need from the cab:
Constant 12V
Switched 12V
Another ground (you can't have too many)
Oil pressure gauge
Water temp gauge
AC control??
From the harness going into the cab:
VSS
Tach
Check engine light (will need a ground on the other end)
OBD2 connector
Torque converter lockup
Fuel pump/fan wires usually come from the harness fuse/relay block. So they will stay in the eng compartment and go from there.
I might be missing something, but those are the basics.
Bubba
|