View Single Post
Old 10-23-2018, 09:43 PM   #5
Bloodhound
Registered User
 
Join Date: Dec 2011
Location: Massachusetts
Posts: 249
Re: 700R4 input shaft

Quote:
Originally Posted by GRADYS Performance View Post
That 1 1/8" figure will vary a little bit case to case and converter to converter. it sounds like the converter is all the way in thee trans. When you bolt the motor and trans together make sure you have at least 1/8" between converter and flexplate.
Ok good to know it's not a hard and fast rule. Tomorrow night Ill line them up and see where it's at.
Bloodhound is offline   Reply With Quote