Nice work on the Square body.
Looking Good.
I will stay tuned too see your idea you use for the drain issue.
It could save me some modification time.
I did not realize you was doing a restoration in your first post.
Since you are I will share my thought on this.
I have my cab off the frame and it is just a bare cab currently.
I am going to bolt the fender on
and see if there is enough room to change the angle from what is now
(approximately) 10 degrees
and try to increase it to 15 to 25 degrees which will
let the leaves and stuff wash out easier.
Of coarse metal will have to be
added and removed and the fender tapering down will factor in.
It just something I am going to look into while I am in the build.
One of the best memories I have of these trucks is
getting in my Grandpa's 71 Chevy
and opening the side vent
so the leaves would go flying around in the cab
Grandpa always got a kick out of my Free entertainment.