Quote:
Originally Posted by dldowner
Is that bolt holding the spline/yoke a right or left thread?
|
Right handed (Standard) bolt is fine thread and will be tough to break loose. An Impact will get it done. once the bolt is out a set of long jaw pullers and a little heat should get the yoke off. Same with the bearing.
Use red scotch bright and clean up the shaft before installing the new bearing and use the proper size bearing driver to seat the new bearing in position.
Once it is reassembled (Use new u-joints as they are inexpensive and now is the time to get that done) install and tighten the carrier bearing mount with the wheels on the ground and the suspension laden.