The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**OL SKOOL** · 12-30-2018, 05:16 AM

I have just disassembled a tilt column to sand blast and paint. I took a lot of pics on my phone but I can't pull them up. I looked on you tube several on there. Unless your going to take the whole column apart. You will probably going to have to take the wires out of the connector. I just used a small cotter pin to get the wires out of the connector. Wrap a string or lite wire around the switch wires and pull it through. You will have to do the same to the new switch and pull back through. Sorry I couldn't get pics up but new phone and me are not getting along.

12-30-2018, 05:16 AM	#2
OL SKOOL Senior Member Join Date: Feb 2010 Location: rochelle il. Posts: 357	Re: Tilt steering column I have just disassembled a tilt column to sand blast and paint. I took a lot of pics on my phone but I can't pull them up. I looked on you tube several on there. Unless your going to take the whole column apart. You will probably going to have to take the wires out of the connector. I just used a small cotter pin to get the wires out of the connector. Wrap a string or lite wire around the switch wires and pull it through. You will have to do the same to the new switch and pull back through. Sorry I couldn't get pics up but new phone and me are not getting along.